Wireless Trigger Setup

These instructions are a work in progress and may change from time to time based on customer feedback; please let us know if you have any questions about them.

Set the transmitter and receiver to matching channels.

Put batteries in the receiver.

Slide the transmitter onto the camera hotshoe and tighten.

Plug the receiver into the strobe (use the adapter if needed) and turn the power switch to the on position.

Turn on the strobe. (If your strobe allows you to turn off the optical sensor/slave mode do this now.)

Push the test button on the transmitter to test firing of the strobe.

Take photos as normal and the strobe should trigger properly.

Troubleshooting

Turn the transmitter around on the hotshoe. For some cameras, it only works in one direction but can be put on backwards.

Try it with the transmitter closer to the receiver; it could potentially be a problem with range, in which case contact us and we'll send a new unit.